Description

12V DC Electric Compressor R134a comes with mounting bracket

This compressor can be mounted just about anywhere in your vehicle as there is no need for a belt or mechanical drive!

You can mount these compressors in an engine bay, a boot / trunk, under a tray of a ute / pickup or truck! 

You will need a decent alternator with an output of at least 100A and up to manage the 66 Amp current draw that this compressor will require at its full speed rated at 4000 rpm.

Comes with a set of Suction & Discharge pad to MIOR adaptors to allow the use of standard FOR screw on fittings. 

Discharge is #8

Suction is #10

Controlling the compressor

There are two methods to control this compressor…

1. Using the vehicles air conditioning thermostat located in the factory evaporator box / under dash unit to trigger a mini relay. (Not included but can be supplied separately)

2. Using a speed control (varies 3 rpm speeds of 3000rpm  / 3500rpm / 4000rpm) and thermostat combination to trigger a mini relay (Not included but can be supplied separately)

Wiring diagram will be supplied either physically or by e-mail.

Powering the compressor

You will require the following items (These are listed on this website under 12 Volt Fully Electric Compressor Cateory).

1. 100A MIDI Fuse and holder

2. Continuous duty solenoid

3. B&S Cable per metre depending on where you mount the compressor

4. Mini relay

Overall compressor dimensions

Width 122.7mm

Length 172.4mm

Height 135.2mm

Rated Max. Output 1940W

VERY IMPORTANT *COMPRESSOR HAS TO BE MOUNTED AS IN PHOTOS WITH THE TROUGH BOLT MOUNTING POINTS AT THE UNDERSIDE OF THE COMPRESSOR, THIS CAN NOT VARY OTHERWISE COMPRESSOR WILL SUSTAIN DAMAGE OR FAIL*

Additional information