12V DC Electric Compressor R134a
This compressor can be mounted just about anywhere in your vehicle as there is no need for a belt or mechanical drive!
You can mount these compressors in an engine bay, a boot / trunk, under a tray of a ute / pickup or truck!
You will need a decent alternator with an output of at least 120A and up to manage the 66 Amp current draw that this compressor will require at its full speed rated at 2300 rpm.
Comes with a set of Suction & Discharge pad to MIOR adaptors to allow the use of standard FOR screw on fittings.
Discharge is #8
Suction is #10
Controlling the compressor
There are two methods to control this compressor...
1. Using the vehicles air conditioning thermostat located in the factory evaporator box / under dash unit to trigger a mini relay. (Not included but can be supplied separately)
2. Using a speed controller (varies rpm from 1000 ~ 2300) and thermostat combination to trigger a mini relay (Not included but can be supplied separately)
Wiring diagram will be supplied either physically or by e-mail.
Powering the compressor
You will require the following items (These are listed on this website under 12 Volt Fully Electric Compressor Cateory).
1. 120A Circuit breaker
2. Continuous duty solenoid
3. 4 B&S Cable per metre depending on where you mount the compressor
4. Mini relay
Overall compressor dimensions
Width 132mm
Length 209mm
Height 172mm
VERY IMPORTANT *COMPRESSOR HAS TO BE MOUNTED AS IN PHOTOS WITH THE TROUGH BOLT MOUNTING POINTS AT THE UNDERSIDE OF THE COMPRESSOR, THIS CAN NOT VARY OTHERWISE COMPRESSOR WILL SUSTAIN DAMAGE OR FAIL*